A 11/12 roof pitch rises 11 inches vertically for every 12 inches of horizontal run. That converts to an angle of 42.51° from horizontal, a slope of 91.7%, and a slope factor of 1.357. By U.S. building convention this falls into the steep slope-slope category.
This guide covers the math, the practical implications for materials and walkability, the typical applications for a 11/12 pitch, and how it compares to its neighbours on either side of the pitch scale.
11/12 by the numbers
Pitch ratio 11/12 corresponds to exactly 42.51° from horizontal and a slope of 91.7%. The slope factor of 1.357 means actual roof surface is 35.7% larger than the building footprint underneath it.
For a 1,000 sq ft footprint, a 11/12 gable roof has roughly 1357 sq ft of actual roof surface. Order shingles, sheathing, and underlayment against the surface area, not the footprint.
| Property | Value | Notes |
|---|---|---|
| Angle from horizontal | 42.51° | Trigonometric arctan(rise/run) |
| Slope percentage | 91.7% | Rise / run × 100 |
| Slope factor (surface multiplier) | 1.357 | Roof surface is 35.7% larger than footprint |
| Rafter length per ft of run | 1.357 ft | Common rafter scales by slope factor |
| Surface area for 1,500 sf footprint | 2036 sq ft | 536 sq ft of additional roofing material |
| Slope category | steep slope | U.S. residential construction convention |
| Walkability | Fall protection required (above 6/12 per OSHA) | Affects labour cost and pace |
Where 11/12 belongs
A 11/12 pitch is decidedly steep — used on traditional gable cottages, A-frames, and any architecture where the roof itself is a major visual element.
All standard roofing materials work at this pitch. The trade-off is on the installation side — fall protection adds time and labour cost.
Material compatibility
Asphalt shingles install with standard single-layer underlayment. Architectural shingles, metal panels, wood shake (4/12 minimum), concrete and clay tile (4/12 standard), and natural slate (4/12 minimum) all install per their specs.
Walkability and labour
A 11/12 pitch requires fall protection — harness, anchor, and often roof jacks or scaffolding. Plan on 25–50% higher labour cost than for conventional pitches, plus longer install times.
Wet, mossy, or icy conditions reduce walkability by at least one pitch class. Never measure or work on a roof during or immediately after rain or snow.
11/12 vs. neighbouring pitches
Compared to a 10/12 (39.81°), a 11/12 sheds water about 4.2% more efficiently and adds a noticeable degree of visual presence.
Stepping up to 12/12 (45.00°) gains you slightly more attic volume and shedding efficiency at the cost of a small increase in framing material and labour.
Need to run the numbers?Use the free roof pitch calculator on the home page to convert pitch to angle, calculate rafter length, or estimate roof area in any unit.